Philips 42PF9936-37B - Manual (Page 9)

5
Installation
& Press the MENU button on the remote control.
é Use the cursor down to select Install .
“ Use the cursor right to select Language .
Follow the instructions on screen.
‘ Use the cursor up/down to select your preferred language
and press the
OK button to confirm your selection.
( Proceed with the Install menu.
The installation menu contains the following items:
Language
English
Français
Español
Install
Select the menu language
Store TV channels
Install
Language Autoprogram
Autoprogram
Install mode
Install
Install
Start
Antenna
Automatic
Cable
& Select Autoprogram in the Install menu.
é Press the cursor down to select Install mode .
“ Press the cursor right.
Note: It is recommended to keep the predefined
Automatic way of
autoprogramming. In case of difficulties in autoprogramming with the
automatic method, choose for Antenna or Cable whether antenna or
cable signals are present.
When Automatic is selected, the TV will automatically detect
whether or not cable signal input is present.
When
Antenna is selected, the TV will detect antenna signals
and will search for all antenna TV channels available in your local
area.
When
Cable is selected, the TV will detect cable signals and will
search for all cable TV channels available in your local area.
‘ Press the cursor down to select Install .
Note: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. (See Channels
in the TV menu, p. 11.)
( Press the cursor right.
§ The message Searching appears and the progress of
autoprogramming is displayed.
When Autoprogramming is complete, the puck navigates to
Stop. A message appears confirming the completion together
with the total number of channels found.
Note: when you navigate to Stop before autoprogramming is
complete, you are given the option to continue.
Available channels:
- with cable: max. from 1 to 125
- off air: max. from 2 to 69
Note: In case a particular channel is too weak for the
autoprogramming to identify, after installation is complete, you should
tune to that channel by using the digit buttons on the remote control.
If the channel is not acquired, a message will appear that the channel
is not available.
2265.1 am 17-12-2003 13:27 Pagina 5