Philips 42PF9936-37B - Manual (Page 7)

3
Use of the remote control RC4305
3
Note: For most buttons pressing a button once will activate the function. Pressing a second time will de-activate it.
When a button enables multiple options, a small list will be shown. Press repeatedly to select the next item in the
list. The list will be removed automatically after 4 seconds or press
OK to remove immediately.
B
¬
+
-
V
+
-
CH
v
b
i 0
h q
Select
VCR DVD SAT AMP
MENU
OK
1 2 3
4 5 6
7 8 9
0
Ò
®
‡ π †
Active Control
S
®
®
® ®
x
CBL
CC
l
l
x no function
OK Press this button to activate
your choice or to confirm when
in the menus.
S Freeze
To freeze the picture.
Dependent on the input signal,
the function may not be possible.
V Volume
Press + or - to adjust the
volume.
0/9 Digit buttons
To select a TV channel.
For a two digit program number,
enter the second digit before the
dash disappears.To switch
immediately to a selected one
digit TV channel, keep the digit
button pressed a bit longer.
v Press this button repeatedly to
select
AV1 , AV2 , AV3 , AV4 , DVI
or TV channels when in TV
mode, according to where you
connected the accessory devices
(p. 18).
CBL VCR DVD SAT AMP
Press the Select button
repeatedly to select one of the
system modes in which the
remote control can be used.
If no action is being undertaken
within 2 seconds, the remote
control returns to TV mode.
After an action in the selected
system mode the remote control
will remain in this mode for 60
seconds and will then return to
TV mode.
l Backlighting button
Press the Select button more
than 2 seconds.The backlighting
of the buttons
V , CH , ¬ and
the digit buttons stays on for 5
seconds after pressing the
button.
B Power
Press to turn on/off the TV.
The TV is never powered off completely
unless it is physically unplugged.
® Ò ‡ π †
Audio and Video equipment buttons
See p. 19.
U Time display
Q Sound mode
Incredible surround
With stereo transmission, and
when Incredible surround is
selected, it seems as though the
loudspeakers are spread further
apart from one another.
Virtual Dolby surround
Optimal with Dolby surround
signals. Enables you to experience
the effect of Dolby surround Pro
Logic, reproducing a rear sound
effect. See Sound menu, 3D
effect, p. 10.
Note:You can make the same
selection in the Sound menu, Sound
mode, p. 10.
l Alternate audio
When you tune a channel where
SAP (Second Audio Program) is
available, you can toggle between
Main and
SAP . If not available,
only Main can be selected.
CC Closed Caption
On/Off/On during mute
see p. 10
MENU Main menu on/off
see p. 8.
¬ Mute
Interrupt the sound or restore it.
CH Channel selection
To browse through the TV
channels or sources stored.
0 Previous TV channel
Press to display the previously
selected TV channel.
2265.1 am 17-12-2003 13:27 Pagina 3