Philips 42PF9936-37B - Manual (Page 11)

7 7
Time zone
This function allows you to select your local
time zone. Broadcasted time information will
correct the clock display for your local time.
& Select Time zone with the cursor down.
é Press the cursor right to select your local time
zone.
Daylight saving
Daylight saving time is automatically set by specially
broadcasted signals.This menu item allows you to
disable the automatic setting of daylight saving
time.This is useful if you live in an area or state
where daylight saving is not applied, but you receive
channels from other areas where daylight saving
signals are broadcasted.
& Select Daylight saving with the cursor down.
é Press the cursor right to select Automatic for
automatic clock correction for daylight saving
time, based on specially broadcasted signals.
“ Select Off to disable automatic clock
correction based on the specially broadcasted
signals.
Set/Change PIN
& Select Set or Change PIN with the cursor
down.
é If no PIN-code exists yet, the menu item is set
to
Set PIN . Follow the instructions on screen.
If a PIN-code has previously been entered, the
menu item is set to
Change PIN . Follow the
instructions on screen.
All number combinations from 0000 to 9999
are valid numbers.
“ The General menu reappears with a message
confirming that the PIN has been created.
Important:You have forgotten your PIN !
& Select Change PIN in the General menu and
press OK .
é Press the cursor right to enter the overriding
PIN-code 0-7-1-1.
“ Press the cursor again and enter a new
personal 4-digit PIN code.The previous code is
erased and the new PIN-code is stored.
& Select Source with the cursor right.
é Press the cursor down to select one of the external AV inputs.
“ Press the cursor right to enter the list of types of devices
attached to the selected input.
‘ Select the accessory device with the cursor up/down.
Once you have named the source, e.g.VCR, this source will
automatically be selected when your remote control is in VCR
mode, see p. 3, and when you press the v button on the
remote control.
( Press the MENU button on the remote control to turn off all
menus on screen.
§ Press the v button on the remote control.
The Source Select menu appears in which you may select a
source or peripheral connected to be displayed on screen.
Center input - Center in volume
When you have connected a multichannel surround receiver to
the TV, the loudspeakers of the monitor can act as center
speaker, making a separate center speaker unnecessary;
Select
Center input On.
When having selected On you can adjust the Center in volume
with the cursor left/right to correct volume level differences of
the external audio receiver and speakers.
Source
AV1
AV2
AV3
YPbPr
Center input
Center in volume
Settings
Source
2265.1 am 17-12-2003 13:27 Pagina 7