Philips LC7181 - Manual (Page 27)

<
Audio adjustments
•
Press Menu and select Audio in the menu bar. The following Audio adjustments can now be
made for both Computer, Component and Video/S-video input, according to the
instructions under ‘General explanation’:
– Volume
adjusts the sound level;
– Bass
adjusts the bass tones;
– Treble
adjusts the high tones;
– Mute
mutes the sound of the projector.
The volume can also be adjusted with the – Volume + keys on the remote control and local keyboard.
General adjustments
Philips Home Cinema Projector English User guide Garbo Matchline 27
5. Operation
Menu OK AV
Mute Source
Stand
by
Lamp
Temp
Menu OK AV
Mute Source
Stand
by
Lamp
Temp
Menu OK AV
Mute Source
Stand
by
Lamp
Temp
Menu OK AV
Mute Source
Stand
by
Lamp
Temp
Settings Picture
Language
Keystone correction
System information...
Factory reset
Key lock
SmartSave
(more)
Display Audio
Settings Picture
Volume
Bass
Treble
Mute
Display Audio
Settings Display Audio
Off On
The Start-up screen can be shown or suppressed
during start-up.
Picture
(previous)
Start-up screen
SmartSet
Feedback
Lamp counter
Monitor out
On Screen Display Menu
The projector is equipped with the following functions to optimize its use and handling:
•
Press Menu and select Settings in the menu bar.The following settings/adjustments can now
be made for both Computer, Component and Video/S-video input, according to the
instructions under ‘General explanation’:
– Language
To select the required menu language;
– Keystone correction
To correct picture distortion of the vertical keystone type by internal scaling;
– System information
The System Information sub menu contains an overview of the most relevant projector
settings, including information on the hardware and software configuration;
– Factory reset
To reset all user settings to the default factory settings;
– Key lock
To de-activate all remote and local controls.To disable the keylock function keep the OK
button pressed for 10 seconds;
– SmartSave
To switch off SmartSave mode or to select the delay time after which the projector
automatically switches to Standby;
– Start-up screen
To display or suppress the default Philips start-up screen upon the projector’s start up;
– SmartSet
To switch automatic source selection on or off;
– Feedback
To suppress OSD messages. Warning or error messages however are never suppressed;
– Lamp counter
To show the operating time of the lamp, which can be reset after a new lamp has been
installed;
– Monitor out
Enables image on second monitor connected.
General settings