Philips DVD580MT - Manual (Page 35)

Picture Mode, Video Out 35
Picture Mode
Improve the clarity and stillness of the Player’s picture by adjusting
Picture Mode (PIC MODE).
1
Press SYSTEM MENU.
2 GENERAL SETUP will be selected. Press OK.
3 Press 9 to select PIC MODE, then press -.
4 Press 8 or 9 to choose AUTO, HI-RES, or N-FLICKER,
then press OK. Choose Auto to have images appear according
to their standard settings. Choose Hi-Res (High Resolution) to
sharpen the images to a high quality. Choose N-Flicker (no-flicker)
to steady or still the picture.
5 Press SYSTEM MENU to remove the menus.
AUTO MODE
--- GENERAL PAGE ---
TV DISPLAY
PIC MODE AUTO
ANGLE MARK HI-RES
OSD LANG N-FLICKER
SCR SAVER
MAIN PAGE
Video Out
If you used S-Video or Component Video (Pr Pb Y) connections as
described on pages 10-11, set VIDEO OUT to (S-)VIDEO or YCBCR
(for Component Video) by following the steps below.
You only need one video connection between the TV and the Player.
You cannot use S-Video and Component Video at the same time.
If you used the yellow VIDEO (Out) jack on the Player to connect the
Player to the TV, you do not need to adjust VIDEO OUT.
1 Press SYSTEM MENU.
2 Press 9 to select VIDEO OUT SETUP, then press OK.
3 VIDEO OUT will be selected. Press -.
4 Press 9 or 8 to select (S-)VIDEO or YCBCR, then press
OK. Choose (S-)VIDEO if you connected the Player’s S-VIDEO
jack to the TV’s S-Video In jack as described on page 10. Choose
YCBCR if you connected the Player’s Pr Pb Y jacks to your TV’s
Component Video In jacks as described on page 11.
5 Press SYSTEM MENU to remove the menus.
SET YCBCR
--- VIDEO OUT SET PAGE ---
VIDEO OUT (S-)VIDEO
MAIN PAGE YCBCR
1,5
2-4
1,5
2-4
• On the TV, the Component
Video In jacks may be labeled
YUV or Pr/Cr Pb/Cb Y and may
be red, blue, and green.
Cb is similar to Pb. “B” refers to
the blue part of the video. Cr is
similar to Pr. “R” refers to the
red part of the video.
Helpful Hints