Brewer Assist Power - Manual (Page 8)

Document # 99300 RevA 8 Printed in USA © 2008
WARNING
Keep personnel and equipment clear of table be-
fore initiating movement to avoid personal injury
or damage to the equipment.
Foot Control (Figure 9)
Depress the pedal at the desired location to activate the
function shown.
NOTE: The table incorporates a safety switch which pre-
vents the leg rest from moving if the treatment pan is not
fully stored (inward).
CAUTION
The foot control is moisture resistant and runs on
low voltage, eliminating shock hazards. However,
to avoid temporary or permanent damage to the
foot control, do not immerse in water or liquids.
CAUTION
Keep foreign objects away from foot control. To
avoid accidental operation, be sure the foot control
is NOT positioned below the legrest or headrest
linkage. Failure to do so could result in unwanted
motion and possible damage to the table.
General
DANGER
Do not use this table in an explosive or oxygen-
rich atmosphere. To do so will result in an explo-
sion or fire.
WARNING
If the table malfunctions, immediately remove your
hand or foot from the controls, unplug the power
cord from the electrical receptacle, and assist the
patient from the table. If table continues to mal-
function, call for service. Do not attempt to repair
table yourself.
WARNING
Before initiating power, keep personnel and equip-
ment clear of the table movement to avoid person-
al injury or equipment damage.
OPERATION
NOTE: Each control function will automatically stop mov-
ing when either the UP or DOWN travel limit is reached.
If the button is pressed with travel at its limit, the actua-
tor will not run. Sensors prevent the actuator motor from
operating when travel limit has been reached, preventing
wear of the actuator.
NOTE: For optimum table performance, allow the table to
reach room temperature before operating.
NOTE: The table is not designed for continuous opera-
tion. The control system includes a thermal overload
safety switch to protect from overheating. If the table is
operated continuously causing the control to exceed its
allowable operating temperature, the thermal overload
safety switch will shut off. If normal operation ceases, do
not attempt to operate the table. Allow the table to cool
for 10-15 minutes before attempting to use again. The
thermal overload switch will automatically reset when it
has reached a safe operating temperature.
NOTE: The control system is protected by a fuse to
prevent excessive current draw which could damage
the system. If operation does not resume after a cooling
period of one hour, contact your dealer or an authorized
service center for repair.