Brewer Assist Power - Manual (Page 11)

Document # 99300 RevA 11 Printed in USA © 2008
Figure 14. Legrest Positions
Legrest Positions (Figure 14)
The legrest can be adjusted from a horizontal position to
a vertical position.
1. To adjust the legrest from a vertical position to a
horizontal position, depress and hold the Legrest/Up
pedal until the desired angle is achieved, then release
the pedal.
2. To adjust the legrest from a horizontal position to a
vertical position, depress and hold the Legrest/Down
pedal until the desired angle is achieved, then release
the pedal.
Legrest Position Control
NOTE: A safety switch inhibits operation of the legrest
function when the treatment pan tray is extended prevent-
ing the legrest from contacting the treatment pan tray. If
the legrest is inoperable, check to ensure that the treat-
ment pan tray is in its fully stowed position (inward). A
light clicking sound will be heard just before the treatment
pan reaches its fully stowed position.
NOTE: The legrest mechanism is controlled by an actua-
tor that raises the legrest when activated. When lowered,
the actuator retracts and gravity causes the legrest to
lower.
Legrest Extension (Figure 15)
In the horizontal position, the legrest can be extended 5”
to increase the overall length of the table.
Lift up on the legrest and pull outward to extend the
legrest. To return the legrest to the shortest position, lift
up on the legrest and push fully inward.
Figure 15. Legrest Extension
CAUTION
To prevent damage to the unit, the legrest must be
returned to the shortest position prior to lowering
the legrest to the vertical position.
TABLE ADJUSTMENTS (CONTINUED)