Brewer Assist Power User Manual

Page 10

Document # 99300 RevA

TABLE ADJUSTMENTS (CONTINUED)

Tilt Function (Figure 12)

The table top can be tilted to any angle between

horizontal and +30° (foot end of table raised).

1. To tilt the foot end of the table upward, depress

and hold the Tilt/Up pedal until the desired angle is

achieved, then release the pedal.

2. To tilt the foot end of the table downward, depress

and hold the Tilt/Down pedal until the desired angle

is achieved, then release the pedal .

NOTE: The headrest linkage may contact the floor or other

object when the table is tilted (Figure 13). If this occurs,

raise the table, reduce the amount of tilt, or raise the back.

Figure 12. Tilt Function

Figure 11. Adjusting Backrest

Backrest Position Control

Figure 13. Do Not Allow Headrest to Contact Objects

Back Positions (Figure 11)

The back can be adjusted to any angle between horizon-

tal and 85°.

1. To adjust the back from a chair (upright) position to a

horizontal position, depress and hold the Back/Down

pedal until the desired angle is achieved, then release

the pedal.

2. To adjust the backrest from a horizontal position to a

chair (upright) position, depress and hold the Back/Up

pedal until the desired angle is achieved, then release

the pedal.

NOTE: The back is controlled by an actuator that raises

the back when activated. When lowered, the actuator

retracts and gravity causes the back to lower.

Tilt Function Control