Philips PerfectDraft Bierzapfanlage - Manual (Page 19)

5 You can remove the tap handle by pulling it out of the tap body.
6 Clean the tap unit, the drip tray and the drip tray cover with hot
water and, if necessary, some washing-up liquid.
Hot water may cause burns. Always check if the water is not too hot
before you clean these parts under the tap.
Only the drip tray, the drip tray cover and the spout are dishwasher-
proof.
Environment
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment.
Disposal of the cooling element
The cooling element inside the appliance contains a substance
that may pollute the environment. Therefore you must remove
the cooling element before you discard the appliance.
You can also take or send the appliance to a Philips service centre. The staff
of this centre will remove the cooling element for you and will dispose of it
in an environmentally safe way.
Only remove the cooling element when you discard the appliance!
Be careful of the paste on the cooling element and adjacent parts. If this
paste ends up on your clothes, it causes a permanent stain.
Remove the cooling element in the following way:
1 Unplug the appliance.
Slide the release button to the right to open the doors.
There are two holes near the hinges of the doors on either side.
Remove the four screws located in these holes with a screwdriver.
Remove the back cover from the appliance.
,
,
,
,
EnglisH 1