Philips PerfectDraft Bierzapfanlage - Manual (Page 10)

Placing the tap unit onto the keg
Always clean the tap unit with hot water and, if necessary, with some
washing-up liquid before you place it on the keg and insert the tube.
1 Remove the protection cap and the tube from the keg.
Put the tap unit onto the connection top of the keg by pushing it
down firmly (‘click’).
If you snap the tap unit onto the keg correctly, it fits nicely between the
two chimes of the keg.
Tip: If you can move the arm of the connection top freely up and down, the tap
unit is placed properly on the keg.
Placing the tube into the tap unit
1 Insert the flexible tube into the tap body.
Slide the projections of the tube connector under the hinge points.
Push the tube connector into the opening in the tap unit (‘click’).
EnglisH
10