Barco R9002139 - Manual (Page 7)

Location and Functions of Control
2-1 5975039 BARCOVISION 508 100698
2
LOCATION AND FUNCTIONS OF CONTROL
Rear Panel Terminology
Communication port (800 peripherals)
• allows communication between the RCVDS switcher and the
projector.
• allows connection of a remote IR receiver unit to the projector.
IR Remote - Remote input for wired remote control
IR sensor Receiver for control signals transmitted from the
RCU.
RGB-S IN or (R-Y)Y(B-Y)-S IN (4x BNC connector):
RGB-S in : allows a character generator, video camera, etc.
having analog RGB output to be connected to the projector.
Line inputs: - signals RED-GREEN-BLUE
- COMPOSITE sync. signal
(R-Y)Y(B-Y)-S in : allows to connect e.g. a professional VCR
having component outputs to the projector.
Line inputs: - signals RED-LUMA,LUMA,BLUE-LUMA
- COMPOSITE sync. signal
VIDEO IN (Composite video, 1x BNC connector): allows
a video tape recorder, video camera, color receiver/monitor,
etc. having video line output to be connected to the projector.
S-VIDEO IN: Separated Y/C (luma-chroma) signal inputs and
outputs for higher quality playback of Super VHS signals (4-
pin S-VIDEO connector).
3
4
2
1
5
Auto diagonisis display
STD BY / NORMAL
PAUSE
COINCIDENCE
EHT HOLD DOWN
IR CODE RXD
Local key Pad
Power (Mains) Switch: Press this switch to turn on the
projector.
Depending on the software set-up of the projector during
installation, the projector switches to ' standby ' or to '
operational mode '. If in standby, the standby led in the
autodiagonosis display lights up.
Power (Mains) input: Connect the supplied ac power
(mains) cord here and to the wall outlet.
Audio output : only if the tuner option is installed. Audio out
to be connected to audio amplifier.
RF input : only if the tuner option is installed.
Input for RF signals from a TV cable network or a TV antenna.
7
6
8
Front Panel Terminology
1
2
1
2
3
4
5
6
7 8
9
10
9
10
1 2
Audio ( Input, ON-OFF Switch, Output )
IR SENSOR Receiver for control signals transmitted from the
RCU.
11
12
11
12