Barco R9002139 - Manual (Page 14)

Connections
3-5 5975039 BARCOVISION 508 120198
Connecting a RCVDS 05 switcher to the projector.
- Up to 10 inputs (20 inputs when video and S-video) with the RCVDS
05 switcher and up to 90 inputs when 10 RCVDS switchers are
linked via the expansion modules.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the projector
(source selection and analog settings)
- The selected source number will be displayed on a 2 digit display
and the selected input modules will be indicated with a LED on the
rear.
For more information about the use of the RCVDS 05, consult the
Owner's Manual, order number: R5975765.
Connecting a VS05 switcher to the projector.
The VS05 can switch up to 5 Composite Video sources, 3 S-Video
Sources and 1 RGB analog or component Video source to the
projector. In addition, the audio signal proper to the source, can be
switched to an audio amplifier.
Order number : R9827890.
For more information about the use of the VS05, consult the Owner's
Manual, order number: R5975245.
Peripheral equipment
Connecting an IR Remote Receiver to the
projector
This infra-red receiver unit makes it possible to control the projector
from another room. There is a communication line cable between the
IR receiver and the projector or the RCVDS. The infrared control
information from the Remote Control Unit is sent to the IR Remote
Receiver. The IR Remote Receiver 800 displays the selected source
on a 7-segment display.
Order number : R9827515.
1 2
Connecting an external audio signal to the
projector: (optional)
Connect an external audio signal the audio input of projector is only
possible when the tuner option is installed.
Connect your external source to the audio input (2 x
cinch connector).
Connect external loudspreakers (Left and right) to the
loudspeaker outputs of the projector.
Connecting speakers wires.
Peel back the vinyl covering and twist the wire core.
Push with your finger on the black lever of the R(right)
speaker input and connect the speaker's minus (-)
wire to the terminal. Remove your finger from the
lever and gently pull the wire to confirm that it is
securely connected.
Push with your finger on the red lever of the R(right)
speaker input and connect the speaker's plus (+)
wire to the terminal. Remove your finger from the
lever and gently pull the wire to confirm that it is
securely connected.
Repeat the same procedure for the left speaker.
Speaker switch.
With the switch on the front panel it is possible to
select external loudspeakers or internal loudspeak-
ers.
10 mm