BT Domus - Manual (Page 8)

8
BT Domus – Issue 2 – Edition 4 – 22.08.07 – 8314
If you experience any problems, please call the Helpline on 0870 605 8047 or email [email protected]
2. Insert the Li-ion rechargeable battery supplied into the handset.
Then slide the compartment cover into place.
3. Place the handset on the base to charge for at least 24 hours.
When the handset is fully charged the icon will be displayed.
The handset screen flashes
BASE 1
until it locks onto the base
and changes to the standby screen.
4. After 24 hours, plug one end of the telephone line cord into
the socket marked on the underside of the base and the
other end into the telephone wall socket.
Only use the telephone line cord supplied.
Setting up for multiple packs
If you have purchased a BT Domus multiple pack, you will
need to prepare any additional handsets and chargers for use.
For each additional handset and charger:
1. Connect the small power adaptor to the charger and switch on.
Getting started
Battery low warning
If the icon flashes in the external
display you will need to recharge the
handset before you can use it again.
You also hear a low battery warning
beep once every 60 seconds.
During charging, the
icon will
scroll in the display.
Battery performance
In ideal conditions, a fully charged
battery should give up to 10 hours talk
time or 80 hours standby time on a
single charge.
If the battery is low, your BT Domus
will automatically fast charge them,
otherwise the battery is trickle charged.
After charging your handset for the
first time, subsequent charging time is
about 6–8 hours a day. The battery
and handset may become warm
during charging. This is normal.
Note that a new battery does not
reach full capacity until it has been in
normal use for several days.
To keep your battery in the best
condition, leave the handset off the
base for a few hours at a time.
Running the battery right down at
least once a week will help it last
as long as possible.
8314 Domus UG [Iss.2Ed.4] 22/8/07 10:17 Page 8