Brady 2034 - Manual (Page 19)

_______________________________________________________________________
Getting Started
13
2.3.2 Dip Switch Settings
For proper operation, you must set the baud rate, parity,
and stop bits of the Printer's interface. On the rear of the
Printer, you will find SWITCH 1 (S1), an eight-position
dip switch used to set the Printer's communications
parameters, (see Table 2-3).
NOTE: SWITCH 1 (S1) is not available with the LCD/Keypad Front Panel
Option, (see Section 3.2 when setting the communications parameters
for this option).
S1-1 S1-2 S1-3 S1-4 S1-5 S1-6 S1-7 S1-8
Baud Rate
9600
4800
2400
1200
600
300
19200
TEST/9600
OFF
OFF
OFF
OFF
ON
ON
ON
ON OFF
OFF
ON
ON
OFF
OFF
ON
ON OFF
ON
OFF
ON
OFF
ON
OFF
ON X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X
Word length/Parity
7-Bit /Even
8-Bit /None
X
X X
X X
X ON
OFF X
X X
X X
X X
X
Compatibility Mode
(Form Edge Offset)
Offset =1.10" (27.9mm)
Offset =2.20" (55.9mm) X
X X
X X
X X
X OFF
ON X
X X
X X
X
Present Sensor
Enable
Disable
X
X X
X X
X X
X X
X ON
OFF X
X X
X
Control Codes
Standard
Alternate
X
X X
X X
X X
X X
X X
X OFF
ON X
X
Cutter Enable
Disable
Enable
X
X X
X X
X X
X X
X X
X X
X OFF
ON
Table 2-2 Communications Dip Switch Settings
NOTE: Select the 8-bit word length if you wish to access the foreign
language characters from the ASCII Code chart. These characters
are available in fonts 1–6 and 9.