Barco NIO E-2620 - Manual (Page 41)

Display installation
Nio® medical display systems 41
USB connection
The USB connection allows you to use the display as USB hub, to
which you can connect USB devices, such as a keyboard, mouse
or digital camera.
To connect the USB cable:
Figure 15
1. Connect a PC USB downstream connector to the display’s USB
upstream connector by means of a USB cable.
2. Connect any USB device to one of the display’s USB
downstream connectors.
Cable routing
Routing the signal cables
• Bind the cables in the connector compartment together with
the cable tie inside the connector compartment.
• Put the connector compartment cover back on the display.
Pay attention that the signal cables are positioned under the
bulge in the cover.
• Push the cables into the clips on the rear of the tilt & swivel
foot.
(1)
(2)