Brother CS-8150 - Manual (Page 45)

Replacing the Needle 39
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
6
While holding the needle with your left hand,
use the screwdriver to tighten the needle
clamp screw.
Install the twin needle in the same way.
■ Using the needle-changing tool
Use the enclosed needle-changing tool to replace
the needle as described below.
1
Pass the needle through the hole in the
needle-changing tool.
2
Lift up the needle-changing tool so that the
fork hooks onto the needle clamp screw.
3
Using the screwdriver, loosen the needle
clamp screw.
● Be sure to insert the needle until it
touches the needle stopper and securely
tighten the needle clamp screw with the
screwdriver, otherwise the needle may
break or damage may result.
CAUTION
S3_brotherE.book Page 39 Thursday, May 15, 2003 1:58 PM