Brother FAX-2480C - Manual (Page 80)

Chapter 10
64
Remote Retrieval
10
You can call your machine from any touch
tone telephone or fax machine, then use the
remote access code and remote commands
to retrieve fax messages.
Setting a Remote Access
Code
10
The remote access code lets you access the
remote retrieval features when you are away
from your machine. Before you can use the
remote access and retrieval features, you
have to set up your own code. The factory
default code is inactive code (---l).
a
Press Menu, 2, 5, 2.
b
Enter a three-digit code using numbers
0-9, l, or #.
Press OK. (The preset ‘l’ cannot be
changed.)
Note
Do not use the same code as your fax
receive code (l 5 1) or telephone answer
code (# 5 1). (See Using external and
extension telephones on page 49.)
c
Press Stop/Exit.
Note
You can change your code at any time by
entering a new one. If you want to make
your code inactive, press Clear/Back in
step b to restore the inactive setting
(---l) and press OK.
Using your Remote Access
Code
10
a
Dial your fax number from a touch tone
telephone or another fax machine.
b
When your machine answers, enter
your remote access code (3 digits
followed by l) at once.
c
The machine signals if it has received
messages:
„ 1 long beep — Fax messages
„ 2 long beeps — Voice messages
(FAX-2580C only)
„ 3 long beeps — Fax & Voice
messages (FAX-2580C only)
„ No beeps — No messages
d
When the machine gives two short
beeps, enter a command.
The machine will hang up if you wait
longer than 30 seconds to enter a
command.
The machine will beep three times if you
enter an invalid command.
e
Press 9 0 to reset the machine when you
have finished.
f
Hang up.
Note
If your machine is set to Manual mode
and you want to use the remote retrieval
features, wait about 2 minutes after it
starts ringing, and then enter the remote
access code within 30 seconds.