Speaker volume, Handset volume (fax-2480c only), Fax-2480c only) – Brother FAX-2480C User Manual
Page 37: 3speaker volume

General setup
21
3
Speaker Volume
3
You can choose a range of speaker volume
levels, from High to Off.
a
Press Menu, 1, 4, 3.
b
Press a or b to choose Low, Med,
High
or Off.
Press OK.
c
Press Stop/Exit.
You can also adjust the speaker volume by
pressing Hook/Hold or Speaker Phone.
a
Press Hook/Hold or Speaker Phone.
b
Press
d
or c
.
This setting will stay until you change it
again.
c
Press Hook/Hold or Speaker Phone.
Handset Volume
(FAX-2480C only)
3
a
Press Menu, 1, 4, 4.
b
Press a or b to choose Low or High.
Press OK.
c
Press Stop/Exit.
You can also adjust the handset volume any
time you are talking on the telephone. There
are two handset volume levels, Low and
High
. The default setting is Low.
Press d or c
to adjust the volume level.
The LCD shows the setting you are choosing.
The new setting will remain until you change
it again.
Choosing the Handset
Volume (For Volume Amplify)
(FAX-2480C only)
3
Before you begin to use the machine, you
must decide if you need to set the handset
volume to Vol Amplify:On for a user who
is hearing-impaired. The AMPLIFY volume
level complies with FCC standards.
Vol Amplify:Off
This default setting is appropriate if none of
the users are hearing-impaired. During a
conversation, users can press
d
or c
on the control panel to adjust the volume to
Low
or High. When the handset is replaced,
the handset volume will remain until you
change it again.
Vol Amplify:On—Temporary
This setting is appropriate if some of the
users are hearing-impaired. During a
conversation, users can press
d
or c
on the control panel to adjust the volume to
Low
, High or Volume Amplify.
When the handset is replaced, the handset
volume returns to the default setting of Low.
Vol Amplify:On—Permanent
Choose Vol Amplify:On—Permanent if all
of the users are hearing-impaired. During a
conversation, users can press
d
or c
on the control panel to adjust the volume to
Low
, High or Volume Amplify. When the
handset is replaced, the handset volume
returns to the default setting of Volume
Amplify
.
Note
When you press
d
or c
on the
control panel to adjust the volume, the
LCD shows the setting you are choosing.
Each key press changes the volume to the
next setting.