Barco R9001870 - Manual (Page 25)

5. Direct source selection
5. DIRECT SOURCE SELECTION
5.1 From standby mode
Using the digit buttons on the Remote Control
1. Make sure that the connected sources to the Cine VERSUM Master are turned on.
2. Using the digit button on the Remote Control, key in the corresponding slot number (from 1 to 8). (image 5-1)
The Cine VERSUM Master powers up and starts on its turn powering up the connected displays. Image of the selected source
appears on the display.
Image 5-1
Digit buttons on Remote Control
Using the standby button on the Remote Control
1. Make sure that the connected sources to the Cine VERSUM Master are turned on.
2. Using the standby button on the Remote Control, press the standby button. (image 5-2)
The Cine VERSUM Master powers up and starts on its turn powering up the connected display. The image of the last selected
source will be redisplayed on the connected dipslay.
Image 5-2
Standby button on Remote Control
R5976490 CINE VERSUM SYSTEM 17012003 21