Barco R9001870 - Manual (Page 19)

4. SWITCHING ON/OFF THE CINE VERSUM SYSTEM
4. SWITCHING ON/OFF THE CINE VERSUM SYSTEM
Overview
• Brief introduction
• Upon first startup
• Switching the system between OPERATION and STANDBY
• Switching the system between STANDBY and ECONOMIC Standby
• Switching the system OFF completely and BACK to Operation mode
• Turning ON the system from total OFF mode
4.1 Brief introduction
About the handled system in this manual
The Cine VERSUM is a modular system that provides you the possibility to connect more than one display device to the Cine
VERSUM Master.
In this owner’s manual, we only discuss the most common case : one Master linked to one Projector. For info on the more complex
systems, please review the installation manual.
This is the chapter’s structure:
• Upon first startup
• Switching the system between OPERATION mode and STANDBY
• Switching the system between STANDBY and ECONOMIC STANDBY
• Switching the system OFF completely and BACK TO OPERATION mode.
4.2 Upon first startup
Required steps
There are two steps upon first startup:
1. Press the power switch (A) on the Cine VERSUM Master. (image 4-1)
The Cine VERSUM Master goes from OFF to STANDBY, visualized by blinking of the standby indicator (B).
2. Press the power switch (A) on the Cine VERSUM 80. (image 4-2)
The Cine VERSUM 80 goes from OFF to STANDBY, visualized by blinking of the standby indicator (B).
3. Select “Power up” in the menu on the Cine VERSUM Master, using the jog dial. (image 4-3, image 4-4)
The Cine VERSUM Master and the Cine VERSUM 80 go from STANDBY to operation, visualized by lighting up of the proper
standby indicator (B).
Image 4-1
Cine VERSUM Master
R5976490 CINE VERSUM SYSTEM 17012003 15