Barco R9001870 - Manual (Page 17)

3. OVERVIEW USER’s CONTROLS
How to reinstall the address
By removing the batteries, the address in the Remote Control will be set to 0. In case the different modules are controlled separately
(own address), the respective address of the module you desire to control has to be set. To reinstall an address, follow procedure
below:
1. Point the Remote Control to the module of which you want to know the address and press the address button (use a pencil).
(image 3-9)
On the screen appears a message box (image 3-10) indicating the address number. In the graphical display of the Cine VERSUM
Master appears the same message (image 3-11).
2. To adapt the address in the Remote Control, cover the IR transmitting diodes and press the address button once, followed within
the 5 seconds by pressing the corresponding digit button, 1 to 8.
Image 3-9
Image 3-10
Message address on-screen
Image 3-11
Message address display master
3.5.3 Visualization of commands
How the commands are visualized
When a button on the Remote Control or the dial knob on the Cine VERSUM Master is pressed, the command is visualized on the
screen of the plasma display or of the projector and also on the graphical display of the Cine VERSUM Master. This can take the
form of a menu, a message or a bar scale. Below an illustration of each item:
Image 3-12
On-screen main menu
Image 3-13
Main menu on Master display
R5976490 CINE VERSUM SYSTEM 17012003 13