Neff C47D22N3GB User Manual
Neff Mini computers
Table of contents
Document Outline
- [en] Instruction manual
- Ú Table of contents[en] Instruction manual
- Your new appliance 6
- Your accessories 7
- Before using for the first time 8
- Operating the appliance 9
- Electronic clock 11
- Automatic programmes 12
- Childproof lock 14
- Basic settings 15
- Automatic safety cut-out 15
- Care and cleaning 15
- Troubleshooting 19
- After-sales service 21
- Environmental protection 21
- Tables and tips 22
- Test dishes 27
- : Important safety information
- Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners.
- This appliance is only intended to be fully fitted in a kitchen. Observe the special installation instructions.
- Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport.
- Only a licensed professional may connect appliances without plugs. Damage caused by incorrect connection is not covered under warranty.
- This appliance is intended for domestic use only. The appliance must only be used for the preparation of food and drink. The appliance must be supervised during operation. Only use this appliance indoors.
- This appliance may be used by children over the age of 8 years old and by persons with reduced physical, sensory or mental capabilities or by persons with a lack of experience or knowledge if they are supervised or are instructed by a person responsi...
- Children must not play with the appliance. Children must not clean the appliance or carry out general maintenance unless they are at least 8 years old and are being supervised.
- Keep children below the age of 8 years old at a safe distance from the appliance and power cable.
- Always slide accessories into the cooking compartment correctly. See "Description of accessories in the instruction manual.
- Risk of fire!
- Risk of burns!
- Risk of scalding!
- Risk of injury!
- Risk of electric shock!
- ■ Incorrect repairs are dangerous. Repairs may only be carried out by one of our trained after-sales engineers. If the appliance is faulty, unplug the mains plug or switch off the fuse in the fuse box. Contact the after-sales service.
- Risk of electric shock!
- Risk of electric shock!
- Risk of electric shock!
- Risk of electric shock!
- Causes of damage
- Automatic calibration
- Inserting accessories
- Cooking compartment
- Optional accessories
- Setting the water hardness range
- Caution!
- Notes
- 2. Press and hold the ± information button until ™‚ ‹ appears in the temperature display.
- 3. Briefly press the ± information button repeatedly until ™†ƒ appears in the temperature display (water hardness "medium").
- 4. Use the temperature selector to set the water hardness.
- 5. Press and hold the ± info button for 3 seconds.
- Caution!
- First use
- 1. Press the operating mode selector so that it pops out.
- 2. Fill and insert the water tank (see section: Filling the water tank).
- 3. Turn the operating mode selector round to é Steam cooking.
- 4. Press the Start button.
- 5. Press theKJ clock function button to exit the clock function.
- 6. Turn the operating mode selector back to the Û position and click in place to turn off the appliance.
- 1. Press the operating mode selector so that it pops out.
- Cleaning the accessories before use
- Switching on the appliance
- 1. Press the operating mode selector so that it pops out.
- 1. Open the appliance door carefully.
- Switching off the appliance
- After each use
- Emptying the water tank.
- 1. Open the appliance door carefully.
- 2. Remove and clean the water tank.
- Caution!
- Drying the cooking compartment
- 2. Once it has cooled down, wipe out the cooking compartment and the evaporator dish with the enclosed cleaning sponge and dry well with a soft cloth.
- 3. Remove food residues in the cooking compartment as soon as the appliance has cooled down.
- 2. Press the KJclock function button briefly.
- Timer
- Cooking time
- Preset operation
- 1. Set the operating mode and temperature.
- 2. Press the clock function button repeatedly until the KJ and x symbols light up.
- 3. Set the cooking time with the rotary selector (e.g. ‚:„‹ hours).
- 4. Press the clock function button repeatedly until the KJ andy symbols light up.
- 5. Set the end of operation using the rotary selector (e.g. ‚ƒ:„‹).
- Setting the clock
- Checking, correcting or deleting settings
- 1. To check your settings, press the KJ clock function button repeatedly until the corresponding symbol lights up.
- 2. If necessary, you can correct your setting using the rotary selector.
- 2. Press the n button.
- 3. Select the programme with the temperature selector.
- 4. Press the n button again.
- 5. Turn the temperature selector to set the weight.
- 6. Press the Start button.
- Notes about the programmes
- Permanent lock
- Locking the appliance permanently
- 2. Press and hold the ± info button until™‚‹ (Appliance locked) appears.
- 3. Turn the temperature selector until™ƒ‚ (Appliance permanently locked) appears.
- 4. Press and hold the ± info button for 3 seconds.
- 2. Turn the temperature selector until ™ƒ‹ (Appliance unlocked once) appears.
- 3. Press and hold the ± info button until the ‚ symbol goes out.
- 4. Switch the appliance on within 30 seconds.
- 2. Turn the temperature selector until ™ƒ‹ (Appliance unlocked once) appears.
- 3. Press and hold the ± info button until the ‚ symbol goes out.
- 4. Within 30 seconds, press and hold the info button ± again for 3 seconds.
- 5. Turn the temperature selector until™‚‹ (Appliance unlocked) appears.
- 6. Press and hold the ± info button for 3 seconds.
- 2. Press and hold the ± information button until ™‚‹ (Lock is not activated) appears in the temperature display.
- 3. Briefly press the ± information button repeatedly until the desired basic setting is displayed.
- 4. Use the temperature selector to change the basic setting.
- 5. Press and hold the ± info button for 3 seconds.
- Caution!
- Caution!
- Descaling
- Descaler
- Caution!
- Risk of surface damage
- Starting descaling
- 1. Press the operating mode selector to make it pop out.
- 2. Turn the operating mode selector to Í Descale.
- 3. Slide in the water tank containing the descaling solution and close the appliance door.
- 4. Press the Start button.
- 2. Rinse the water tank thoroughly, fill with water and reinsert.
- 3. Remove the descaling solution from the evaporator dish using the cleaning sponge provided.
- 2. Thoroughly rinse out the cleaning sponge.
- 3. Remove the remaining water from the evaporator dish using the cleaning sponge.
- 2. Remove the remaining water from the evaporator dish using the cleaning sponge.
- 3. Wipe out the cooking compartment using the cleaning sponge and then dry with a soft cloth.
- 4. Turn the operating mode selector back to Û.
- 2. Completely fill the evaporator dish with descaling solution.
- 3. Fill the water tank with water only.
- Removing and fitting the appliance door
- : Risk of injury!
- : Risk of injury!
- Removing the appliance door
- 2. Fold out the locking levers on the left and right fully (figure A).
- 3. Close the appliance door until you feel some resistance.
- 4. With both hands, grip the door on the left and right-hand side, close the door a little more and pull it out (Fig. B).
- 2. Open the appliance door fully.
- 3. Close the locking levers on the left and right-hand side fully (figure D).
- Cleaning the door panels
- Cleaning the rails
- : Risk of burning due to hot components in the cooking compartment!
- Note
- 2. Detach the rail from the holder and remove it (fig. B).
- 2. Hook the rail in at the back and push it towards the rear until it engages (fig. C).
- 3. Hook the front of the rail onto the holder and press down until it engages and is fixed level in place in the appliance once more (fig. D).
- Replacing the cooking compartment bulb
- : Risk of burns!
- 2. Turn the cover anti-clockwise to remove.
- 3. Screw out the bulb by turning it anti-clockwise and replace with a bulb of the same type.
- 4. Slide the new seals and the clamping ring onto the glass cover in the right order.
- 5. Screw the glass cover with the seals back on again.
- 6. Connect the appliance to the mains and reset the clock.
- Changing the door seal
- Tips for saving energy
- Cookware
- Cooking time and quantity
- Distributing food evenly
- Pressure-sensitive food
- Cooking a menu
- Vegetables
- Fish
- Soup vegetables, Miscellaneous