Neff C47D22N3GB - Manual (Page 15)

15
Basic settings
Your appliance has various basic settings, which are preset at
the factory. You can change the basic settings as you require.
If you want to cancel all the changes, you can restore the
factory settings.
You can only change the basic settings if the appliance is
switched on.
1. If required, turn the operating mode selector to Û .
2. Press and hold the ± information button until ™‚‹ (Lock is
not activated) appears in the temperature display.
3. Briefly press the ± information button repeatedly until the
desired basic setting is displayed.
4. Use the temperature selector to change the basic setting.
5. Press and hold the
± info button for 3 seconds.
The change is saved.
You can change the following basic settings:
Automatic safety cut-out
The automatic safety cut-out is only activated if you have not
made any settings on your appliance for a prolonged period.
The length of time after which your appliance switches itself off
depends on the settings that you make.
‹‹‹ flashes in the temperature display. Cooking is interrupted.
Turn the operating mode selector back to the Û position to
deactivate the automatic safety switch-off function. You can now
make new settings.
Care and cleaning
In this section, you will find information on
■
the care and cleaning of your appliance
■
Descaling
:
Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of surface damage: Do not use
■
harsh or abrasive cleaning agents
■
oven cleaners
■
corrosive or aggressive cleaners, or those containing
chlorine
■
cleaning agents with a high alcohol content
If such an agent comes into contact with the front of the
appliance, wash it off immediately with water.
Basic settings menu
Submenu
Basic setting Setting
symbol
Childproof lock Lock is not activated ™‚‹
Lock is activated ™‚‚
Permanent lock is activated ™ƒ‚
* Restore the appliance to the factory settings:
■
all changes to the basic settings are cleared
■
Automatic calibration is carried out again
Audible signal Audible signal off ™„‹
Audible signal duration
30 seconds
™„‚
Audible signal duration
2 minutes
™„ƒ
Audible signal duration
10 minutes
™„„
Auto start off ™…‹
on ™…‚
Water hardness
range
softened ™†‹
soft (I) ™†‚
medium (II) ™†ƒ
hard (III) ™†„
very hard (IV) ™†…
Steam heating up
signal
off ™‡‹
on ™‡‚
Factory settings* Do not restore ™ˆ‹
Restore ™ˆ‚
Basic settings menu
Submenu
Basic setting Setting
symbol
* Restore the appliance to the factory settings:
■
all changes to the basic settings are cleared
■
Automatic calibration is carried out again