Neff C47D22N3GB - Manual (Page 20)

20
Replacing the cooking compartment bulb
Heat-resistant 25 W, 220/240 V bulbs, E14 bulb sockets and
the seals are available from the after-sales service. Please
specify the E number and FD number of your appliance.
:
Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
1. Switch off the fuse in the fuse box or unplug at the mains.
2. Turn the cover anti-clockwise to remove.
3. Screw out the bulb by turning it anti-clockwise and replace
with a bulb of the same type.
4. Slide the new seals and the clamping ring onto the glass
cover in the right order.
5. Screw the glass cover with the seals back on again.
6. Connect the appliance to the mains and reset the clock.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Changing the door seal
If the seal around the outside of the cooking compartment is
faulty, it must be replaced. Replacement seals for your
appliance can be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
1. Open the appliance door.
2. Pull off the old seal.
3. Push in the new door seal at one point and pull it in all the
way round. The joint must be at the side.
4. Check again that the seal is correctly fitted in the corners.
Steam escapes from the ventilation slots
during cooking
This is normal
The appliance is not producing steam
properly
Limescale has formed in the appliance Starting descaling
The error message “‹‚‚ appears in the
temperature display
A button was pressed for too long or is
jammed
Press the KJ clock function button to
delete the error message.
Press all of the buttons individually and
check if they are clean
An “‹ ... error message appears in the
temperature display
Technical fault Press the KJ clock function button to
delete the error message, and reset the
clock if necessary.
If the error message appears again, call
the after-sales service
The appliance is no longer heating. The
colon is flashing in the clock display.
‚‹‹© , for example, appears in the tem-
perature display
A button combination was actuated Switch off the appliance.
Press the ± information button for
3 seconds, then press the KJ clock func-
tion button for 4 seconds and then press
the
± information button again for another
3 seconds
Problem Possible cause Notes/remedy