Neff U17M52S3GB - Manual (Page 21)

21
Self-cleaning surfaces
The rear wall, ceiling and side walls of the cooking
compartment are coated with self-cleaning enamel. This
coating absorbs and disintegrates splashes from baking and
roasting while the oven is in operation.
Large splashes only disappear after the oven has been used
several times.
Discolouration on the self-cleaning surfaces does not affect the
self-cleaning function.
Caution!
Damage to surfaces on self-cleaning areas due to applying
oven cleaner.Never clean the self-cleaning surfaces with oven
cleaner.
If oven cleaner accidentally gets onto self-cleaning surfaces,
remove it immediately with a sponge and plenty of water.
Caution!
Damage to surfaces on self-cleaning areas due to the use of
abrasive and acidic cleaning agents and aids.
Do not use cleaning agents containing abrasive substances or
acids.
Do not use abrasive cleaning aids such as steel wool or
scourers.
Oven cleaning
If the self-cleaning surfaces (see section: Self-cleaning
surfaces) in the oven no longer clean themselves adequately,
they can be regenerated using the z Oven cleaning operating
mode.
:
Risk of burns!
The appliance becomes very hot during Oven cleaning. Keep
children away from the appliance.
Preparing for oven cleaning
1. Remove accessories and hook-in racks, telescopic shelves
or separate fitting systems from the cooking compartment.
2. Clean the enamel surfaces (smooth surfaces) to avoid any
lasting stains (see section: Cleaning the cooking
compartment).
Starting oven cleaning
1. Main oven õ : Set the operating mode selector to 3
CircoTherm®.
or
Top oven
ô : Set the operating mode selector to % Top/
bottom heat.
2. Set the temperature selector to z Oven cleaning.
3. Heat the appliance for 60 minutes.
Note: You can also set the cooking time clock function to
60 minutes.
Ending/cancelling oven cleaning
Turn the operating mode and temperature selector back to
the Û position.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
1. Open the appliance door fully.
2. Open the locking levers on the left and right-hand side fully.
The hinges are secured and cannot snap closed.
3. Close the appliance door until resistance becomes
noticeable (figure A)
4. With both hands, grip the door on the left and right-hand side,
close the door a little more and pull it out (figure B).
Fitting the appliance door
1. Insert the hinges in the left and right-hand holders (figure C).
The notch on both hinges must engage.
2. Open the appliance door fully.
3. Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4. Close the appliance door.
$ %
& '