Neff B45M54N3GB - Manual (Page 20)

20
Keeping the appliance clean
To avoid getting the cooking compartment dirty,
■
clean the cooking compartment after each use, as dirt will
bake on the next time it is heated up, and this can only be
removed with difficulty
■
always remove flecks of limescale, grease, starch and
albumin (e.g. egg white) immediately
■
use 3 CircoTherm® whenever possible. This operating
mode creates less dirt
■
Use the universal pan to bake very moist cakes
■
use suitable ovenware when roasting (e.g. roasting dish) or a
roasting sheet (see section: Accessories)
Self-cleaning surfaces
The back wall, side walls and ceiling of the cooking
compartment are coated with a highly porous ceramic layer.
This coating absorbs and disintegrates splashes from baking
and roasting while the oven is in operation.
The higher the set temperature and the longer the oven is in
operation, the better the cleaning result. Large splashes only
disappear after the oven has been used several times.
Residues can be removed with water and a soft sponge.
Colour variations on the self-cleaning surfaces have no effect
on the self-cleaning function.
Caution!
■
Damage to surfaces on self-cleaning areas due to applying
oven cleaner.Never clean the self-cleaning surfaces with oven
cleaner.
If oven cleaner accidentally gets onto self-cleaning surfaces,
remove it immediately with a sponge and plenty of water.
■
Damage to surfaces on self-cleaning areas due to the use of
abrasive and acidic cleaning agents and aids.
Do not use cleaning agents containing abrasive substances
or acids.
Do not use abrasive cleaning aids such as steel wool or
scourers.
Oven cleaning
If the self-cleaning surfaces (see section: Self-cleaning
surfaces) in the oven no longer clean themselves adequately,
they can be regenerated using the z Oven cleaning operating
mode.
:
Risk of burns!
The appliance becomes very hot during Oven cleaning. Keep
children away from the appliance.
Preparing for oven cleaning
1. Remove accessories and hook-in racks, telescopic shelves
or separate fitting systems from the cooking compartment.
2. Clean the enamel surfaces (smooth surfaces) to avoid any
lasting stains (see section: Cleaning the cooking
compartment).
Starting oven cleaning
1. Set the operating mode selector to 3 CircoTherm.
2. Set the temperature selector to z Oven cleaning.
3. Heat the appliance for 60 minutes.
Note: You can also set the operating time clock function to
60 minutes.
Ending/cancelling oven cleaning
Turn the operating mode and temperature selector back to
the Û position.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always fully turn the two locks for fitting and removing the
appliance door.
:
Risk of injury!
If the appliance door has been removed without turning both
locking levers to their limit stops, the hinge may snap shut. Do
not reach into the hinge. Call the after­sales service.
Removing the appliance door
1. Open the left and right-hand hinge lock (Fig. A).
To do this, push the hinge lock (Fig. B) fully upwards on both
sides with a screwdriver.
Hinge lock closed (Fig. C)
Hinge lock open (Fig. D)
2. Open the appliance door a little (Fig. E).
3. Using a coin, fully turn both the left and right-hand locks on
the inside of the appliance at the bottom (Fig. F).
Left lock: clockwise
Right lock: anti-clockwise
$ %
& '
( )