Changing halogen bulbs, Risk of burns, Caution – Neff B46E74N3GB User Manual
Page 30: Clouding in halogen bulbs, Reinsert the bulb fitting into the appliance door, Fit the door panel and appliance door, Changing the door seal, Unhooking the door seal, Hooking in the door seal, Check that the door seal is seated correctly
![background image](/manuals/495795/30/background.png)
30
Changing halogen bulbs
Spare bulbs can be obtained from the after-sales service or
specialist retailers. Verwenden Sie nur diese Halogenlampen:
Osram HALOSTAR ECO, 12 V, GY 6.35, 25 W
:
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
1.
Remove the appliance door (see section: Removing and
refitting the appliance door).
2.
Remove the door panel (see section: Cleaning the door
panels).
3.
Unclip the defective halogen bulb and the bulb fitting from the
holder, and carefully remove it from the reflector.
4.
Remove the defective halogen bulb from the bulb fitting
(fig. A).
5.
Insert a new halogen bulb into the bulb fitting. Use a clean
cloth to do this (fig. B).
6.
Reinsert the bulb fitting into the appliance door.
7.
Fit the door panel and appliance door.
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
Unhooking the door seal
The door seal is fixed in nine places.
1.
Unhook (Fig. B) the door seal at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
the hooks slightly (Fig. D).
Hooking in the door seal
1.
Hook (Fig. B) the door seal in at four points (Fig. A).
2.
Hook the door seal in at five further points (Fig. C) by turning
it slightly (Fig. D).
3.
Check that the door seal is seated correctly.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the base of the appliance when you open the
appliance door.
To save time, you can make a note of the number of your
appliance and the telephone number of the after-sales service
in the space below, should it be required.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
Rely on the professionalism of the manufacturer. You can
therefore be sure that the repair is carried out by trained service
technicians who carry original spare parts for your appliances.
%
$
$
%
&
'
E no.
FD no.
Aftersales service
O
GB
0844 8928989
Calls from a BT landline will be charged at up to
3 pence per minute. A call set-up fee of up to 6 pence
may apply.
IE
01450 2655
0.03 € per minute at peak. Off peak 0.0088 € per
minute.