beautypg.com

Getting to know your appliance, The control panel, Notes – Neff N14D30N2 User Manual

Page 13: The hotplates, Residual heat indicator, Setting the hob, Switching the hob on and off

background image

13

Getting to know your appliance

An overview of the models with their dimensions is given on

page 2.

The control panel

Notes

When you touch a symbol, the respective function is

activated.

Always keep the controls dry. Moisture reduces their

effectiveness.

Do not pull pans close to the displays and sensors. The

electronics could overheat.

The hotplates

Residual heat indicator

The hob has a two-stage residual heat indicator for each

hotplate.
If

appears in the display the hob is still hot. It may be used,

for example, to keep a small meal warm or to melt cooking

chocolate. As the hotplate cools down further, the display

changes to

œ

. The display remains lit until the hotplate has

cooled sufficiently.

Setting the hob

This section informs you how to set the hotplates. The table

shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the

#

symbol. A signal sounds. The

indicator above the main switch lights up. The hob is ready for

use.
To switch off: touch the

#

symbol until the display above the

main switch goes out. All hotplates are switched off. The

residual heat indicator remains on until the hotplates have

cooled down sufficiently.

Notes

The hob switches off automatically if all hotplates have been

switched off for more than 15 seconds.

The settings remain stored for 4 seconds after the hob has

been switched off. If you switch it on again during this time,

the hob will operate using the previously stored settings.

Displays

-

Š

Heat settings

/

œ

Residual heat

Keep warm function

‰‰

Timer

Controls

#

Main switch

"

Control panel pause

( )

Hotplate selection

A @

Adjustment fields

ð

Zone activation

Keep warm function/childproof lock

3

Timer

Controls

Hotplate

Activating and deactivating

$

Single-circuit hotplate

ð

Dual-circuit hotplate

Use the ( ) symbol to select the hotplate. Touch the

ð

activation symbol

When the hotplate is activated: the corresponding indicator lights up.