Neff T14T95N2 - Manual (Page 29)

29
■
The diameter of pot and pan bases should be the same size
as the hotplate. In particular, small saucepans on the hotplate
cause energy losses. Please note: cookware manufacturers
often indicate the upper diameter of the saucepan. This is
usually bigger than the diameter of the base of the pan.
■
Use a small saucepan for small quantities. A larger, less full
saucepan requires a lot of energy.
■
Cook with only a little water. This will save energy. Vitamins
and minerals in vegetables are preserved.
■
Always cover as large an area of the hotplate as possible
with your saucepan.
■
Switch to a lower heat setting in good time.
■
Select a suitable ongoing cooking setting. You will waste
energy by using an ongoing cooking setting which is too
high.
■
Use the residual heat of the hob. For longer cooking times,
you can switch the hotplate off 5-10 minutes before the end
of the cooking time.
Getting to know your appliance
The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.
The control panel
Notes
■
When you touch a symbol, the respective function is
activated.
■
Always keep the controls dry. Moisture reduces their
effectiveness.
■
Do not pull pans close to the displays and sensors. The
electronics could overheat.
The hotplates
â Hotplates with bridge heating element
Two individual hotplates can be interconnected with a bridge
heating element to create one large extended cooking zone
Under normal operation, these hotplates both work as normal
single-circuit and dual-circuit hotplates.
To activate the bridge heating element: the single-circuit
hotplate must be switched off.
1. Switch on the dual-circuit hotplate.
2. Touch the ó symbol. The outer filament circuit on the dual-
circuit hotplate is activated. The indicator light lights up.
3. Touch the ó symbol again. The extended cooking zone is
activated. The indicator light lights up.
To deactivate the extended cooking zone: touch the ó symbol
again. The indicator lamp goes out. The extended cooking zone
is deactivated.
You can also change the heat setting using the control panels
for the two hotplates.
Displays
‚ - Š Heat settings
‹ Operating readiness
• / œ Residual heat
– Keep warm function
‰‰ Timer
Controls
# Main switch
– Childproof lock
– Keep warm function
ó Automatic zone control
3 Timer
Controls
Hotplate Activating and deactivating
$ Single-circuit hotplate
ð Dual-circuit hotplate Select the hotplate, touch the ó symbol.
ò Dual-circuit hotplate, hotplate
with extended cooking zone
Select hotplate, touch the ó symbol, 2nd filament circuit is activated.
Touch the ó symbol again, 3rd filament circuit is activated.
When the hotplate is activated: the corresponding indicator lights up.