Sharp LC-60UD20KN - Manual (Page 39)

37
Power save settings
Go to “TV Menu” > “Setup” > “ECO”.
Setup
No signal off
ECO picture control
ECO
Energy save
CH list
:Back :Enter
Menu
No operation off
[Disable]
[Disable]
[Off]
[On]
ECO
ECO picture control
This function automatically detects the image
source and decreases the power consumption while
keeping the brightness of the image unchanged.
NOTE
• This function does not work when “AV mode” is set to
“DYNAMIC (Fixed)”, “DYNAMIC” or “MOVIE THX”.
• This function does not work when “Energy save” is set
to “Standard” or “Advanced”.
• This function is greyed out in 3D mode.
ECO
Energy save
This function enables you to reduce the backlight
brightness in order to decrease the power
consumption and increase the backlight life span as
shown in the following table.
Item
Standard Reduces the backlight brightness.
Advanced
Reduces the backlight brightness more
than “Standard”.
Off
The backlight brightness is the same
value of your settings in the selected
“AV mode”.
NOTE
• This function does not work when “AV mode” is set to
“DYNAMIC (Fixed)” or “MOVIE THX”.
E “Energy save” status icons
Icon Description
“Energy save” is set to “Standard”.
“Energy save” is set to “Advanced”.
When “Energy save” is set to “Standard” or
“Advanced”, “Energy save” status icons appear
in the “Picture” menu and channel information
windows.
ECO
No signal off
When set to “Enable”, the TV will automatically
enter standby mode if there is no signal input for 15
minutes.
NOTE
• Even if a TV programme finishes, this function may not
operate because of interference from other TV stations
or other signals.
ECO
No operation off
The TV will automatically enter standby mode if no
operations are performed in three hours if “Enable”
is selected.
NOTE
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
ECO
Sleep timer
Allows you to set a time when the TV automatically
enters standby mode. You can set the time span for
entering standby mode after selecting “Change”.
NOTE
• Select “Off” to cancel the sleep timer.
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
Basic adjustment