Sharp LC-60UD20KN - Manual (Page 23)

21
Timer setup using EPG
The TV can be switched to a programme or start
recording for USB-recording at the set time.
1 Press EPG.
2 Press a/b/c/d to select the programme you
want to set, and then press ;.
Back to EPG
Watch No Record
Next
3 Press c/d to select “Watch” or “Record”, and
then press ;.
• If you select “No”, the TV returns to the EPG screen.
4 Press c/d to select “Yes”, and then press ;.
• The selected TV programme is marked with an icon.
5 Press ; to select “Back”.
NOTE
• You cannot select “Record” when the registered USB
HDD is not connected to the USB port.
• A combined total of 16 timer settings (“Watch” and
“Record”) can be set.
*Important information:
A CAM (CI Plus v1.3) PIN code may be necessary to
record broadcasts scrambled due to parental rate
settings.
When a CAM PIN code is required for recording a
programme, it is necessary to enter the CAM PIN code
in advance (Page 9).
If a CAM PIN code is not entered or is entered
incorrectly, the programme may not be able to be
recorded/played back.
Cancelling the timer setup
1 Press EPG.
2 Press a/b/c/d to select the programme with
timer setup, and then press ;.
3 Press c/d to select “Cancel”, and then press ;.
4 Press c/d to select “Yes”, and then press ;.
E Cancelling using B button on the
remote control unit
1 Press EPG.
2 Press B to display the timer setup list.
3 Press a/b to select the programme you want
to cancel timer setup, and then press ;.
4 Press c/d to select “Cancel”, and then press ;.
5 Press c/d to select “Yes”, and then press ;.
Watching TV