Sharp XE-A102B - Manual (Page 20)

18
EURO Migration Function
IMPORTANT
• After the execution of the procedure with “A=1”, treat EURO as foreign currency using E. Set
the EURO conversion rate as the currency conversion rate for E.
• After the execution of the procedure with “A=2”, treat EURO as domestic currency and national
currency as foreign currency using E. Set the EURO conversion rate as the currency conversion
rate for E.
• After the execution of the procedure with “A=3”, treat EURO as domestic currency.
• As for the percent rate for
% and HALO setting, the automatic conversion is not made. So, when
your domestic currency becomes EURO, you must change these settings so that they are based
on EURO currency.
• You can receive the amount of exchange (EURO or national currency) in cheque or credit. For
the programming, please refer to EURO programming on page 22.
• When “Exchange amount printing for total and change” is set to “Yes”, you can display a change
in foreign currency by pressing E when the change is displayed in domestic currency.
Checking the current EURO status
You can check the EURO status currently set on the cash register. Set the mode switch to the
Z/PGM position, (if necessary, enter the secret code and press
t) and perform the following
procedure. The current EURO status will be printed on the receipt or journal.
8:SS
EURO status
Items
General Z report
GT memory
Conversion of preset prices of Dept./PLU
Exchange amount printing for total and
change
Exchange calculation method
Domestic currency symbol
Domestic currency decimal point position
Exchange currency symbol
Exchange currency decimal point position
Rounding of exchange currency
A=1
(EURO status 1)
Issue
-
-
Yes
Division
-
-
[EURO]
2
Round off
A=2
(EURO status 2)
Issue
Clear
Yes *
1
Yes
Multiplication
[EURO]
2
Previous domestic currency
symbol
Previous domestic currency
decimal point position
Round off
A=3
(EURO status 3)
Issue
Clear *
2
Yes * 1
No
Multiplication
[EURO]
2
-*
3
-
Round off
• The item marked with “-” remains the same as the previous data.
*
1 : If the Automatic conversion of unit prices of Depts./PLUs by automatic EURO migration
operation is set NO (default setting) in EURO Programming, or currency exchange rate is set to
0% (default setting) in Exchange Key Programming, conversion of preset prices of Dept./PLU is
not performed in the Automatic EURO modification operation.
* 2 : When you perform from EURO status 2, previous data remains unchanged.
* 3 : When you perform from EURO status 1 or 2, “space” is set.
A102_01(E) 05.4.18 9:06 AM Page 18