Sharp MX-C300W - Manual (Page 34)

32
CHANGING THE PORT
4 Select [SC2 TCP/IP Port] and then click
the [New Port] button. 5 Create the new port.
(1) Enter the machine's IP address.
☞
Checking the IP address of the machine
(page 7)
(2) Make sure that [LPR] is selected.
(3) Make sure that [lp] is entered.
(4) Click the [OK] button.
6 Click the [Close] button in the screen of
step 4.
7 Make sure the created printer port is
selected in the printer properties
window and then click the [Apply]
button.
X Changing to a Standard TCP/IP Port
If the machine is being used on an IPv6 network, change the port to a port created using the operating system's
"Standard TCP/IP Port".
1 Follow steps 1 to 3 of "CHANGING THE
PORT" (page 31). 2 Select [Standard TCP/IP Port] and then
click the [New Port] button.
• The "SC2 TCP/IP Port" is added when the printer
driver is installed using a "Custom installation" with
"LPR Direct Print (Specify Address/Auto Search)"
selected.
• If the printer driver is installed using a "Custom
installation" with "IPP" selected, the [SC-Print2005
Port] is added. If you need to change the printer port
when the machine is connected to an intranet or a
wide area network (WAN) using the IPP function,
select [SC-Print2005 Port], click the [New Port]
button, and follow the on-screen instructions to
create the port again.
(4) (1) (2) (3)