beautypg.com

Screen room 89, Fiberglass screening 89, Paneling 89 – Baja Marine JAY SERIES YEAR 2006 User Manual

Page 99: Vinyl floor 89, Screen room, Fiberglass screening, Paneling vinyl floor

background image

DO NOT...

• ...Fold or roll in extreme cold temperatures.
• ...Drag your canopy across any abrasive surfaces, such as a cement drive.
• ...Get insect spray on the fabric, as some solutions may impair the water repellency of

the fabric and cause staining.

• ...Allow water to stand on the canopy, causing pocketing and possible stretching.
• ...Wash your canopy with a harsh strong solution, or scrub too vigorously with an

abrasive cleaner.

• ...Force or yank your canopy when raising or lowering it. Do it gradually.
• ...Charcoal grill underneath the canopy.
• ...Store the canopy when it is damp or wet. Mildew is a fabric’s greatest enemy and is

caused by dampness. Mildew may grow on the surface of a damp canopy and
permanently stain the fabric.

• ...Permit leaves, twigs, etc. To remain on your canopy as they might cause a staining

of the fabric.

• ...Wrap steel or aluminum hardware with the canopy.

Screen Room

Care should be taken when setting up and putting the screen room away to avoid tears and
cuts. When putting away the deluxe screen room, the curtains should be in the down
position and secured to the bottom with their strings.

1. Wash off any droppings or foreign matter from trees with clear water and keep the

vinyl clean when putting away.

2. DO not roll stakes or hardware with the screen room.
3. Never roll the vinyl screen room up wet for any extended period of time.
4. If mildew is apparent, it should be treated promptly with a light solution of Naphtha

soap and water. A soft brush or cloth is recommended for cleaning vinyl.

FIBERGLASS SCREENING

When possible, the fiberglass screening should be loosely folded, not crushed when
opening and putting away the screen room. Do not allow poles and stakes to punch holes in
the screen.

PANELING

The wall paneling in your trailer is a vinyl covered wood panel. If deep scratches occur,
putty sticks can be used to cover them. These can be obtained from hardware stores and
lumber yards. For decor paneling, replacement vinyl covering can be purchased for repairs
if needed. Your independent, authorized dealer’s parts department can assist you with this.

To clean, use a mild solution of soap and lukewarm water with a soft sponge or cloth. DO
NOT use abrasive cleaners. It could cause the vinyl to scratch and turn dull. Grease spots
and stubborn dirt can be cleaned off with an all-purpose spray cleaner.

VINYL FLOOR

To care for the vinyl floor covering, use a damp mop with water and a mild cleaner. DO
NOT SOAK FLOORING.

Jay Series/Baja/Select Folding Camping Trailer

89

Maintaining Your Investment...