Baja Marine JAY SERIES YEAR 2006 - Manual (Page 40)

• Turn the steering wheel as little as possible. Natural lag time reaction when
counter-steering to correct sway could possibly make it worse.
• If the trailer is equipped with electric brakes, using the hand control will help to keep
the vehicles aligned.
• As soon as possible, stop to determine the cause of the sway. Check all equipment
and load distribution.
• If the problem can not be solved immediately, take the equipment to a service center.
Travel at a reduced speed on your way there.
I
WARNING: A sway control device should be used with your tow
vehicle/trailer combination. Consult with a trained hitch installer to
obtain the proper equipment for your needs.
Hitch Height and Hitch Ball Specifications
To determine the hitch height for your model, make sure that the
trailer is level. Measure from inside the hitch coupler to the ground.
Record this number in the box at the side for future reference. If you
have additional questions, consult with your independent, authorized
dealer.
Jayco, Inc. cannot be responsible for the suspension system of any tow
vehicle. There are a variety of suspension systems available on tow vehicles today which
will affect the ball height, stability and levelness of the RV when hooked to the vehicle.
Make certain your independent, authorized dealer is aware of the type of tow vehicle that
will be used so a compatible hookup can be achieved.
Your trailer’s hitch ball size is 2”.
The Hitching Procedure
Hooking up a camping trailer is not difficult and will become easier with practice. The
following procedure will help you until you become more experienced.
1. Make sure the trailer wheels are blocked.
2. Turn the jack crank to raise the trailer tongue above the hitch ball.
3. Open the coupler latch on the trailer hitch.
4. Back the tow vehicle into the proper position.
5. Turn the jack crank to lower the coupler onto the hitch ball.
6. Close the coupler latch after it is completely seated.
7. Install the weight distributing bars (equalizers) as per recommendations from the
hitch supplier, when required.
8. Remove the dolly wheel or platform and retract the tongue jack to its maximum
height.
9. Attach the breakaway switch cable to the tow vehicle.
10. Attach the safety chains as shown in Fig. 4.
11. Plug in the seven (7) pin connector from the tow vehicle to trailer.
12. Remove the trailer wheel blocks.
Refer to the complete list of suggested items in this manual for pre-trip planning and
departing from camp for additional items to complete before traveling.
30 Jay Series/Baja/Select Folding Camping Trailer
Before you travel...
This unit hitch
height is: