Baja Marine JAY SERIES YEAR 2006 - Manual (Page 68)

To replace the filter
1. Drain the water system.
2. Remove the cartridge by disconnecting the fitting at either end of the filter and pull it
out of the fittings. It may be helpful to have a container available under the filter to
catch any water left in the lines or filter.
3. If winterizing the unit, install the bypass hose and store the filter as is appropriate.
4. If replacing the filter, install the new filter and tighten the fittings at either end.
I
CAUTION: Never allow the filter to freeze or come in contact with RV
antifreeze when the trailer water system is winterized. Refer to
complete instructions supplied by the water purification system
manufacturer.
AIR CONDITIONER PREP (OPTION)
Your trailer is equipped with wiring to install an air conditioner. It is recommended that
you have the installation performed by a qualified RV technician only. Refer to the
“Safety” chapter regarding changes, modifications and additions to your trailer.
To comply with State, Federal, ANSI/NFPA codes and (if applicable) Canadian Standards,
as well as Jayco standards, optional air conditioning units must be installed using the
following:
1. 20-amp receptacle with 12 gauge wire.
2. 20-amp power cord to feed air conditioner.
3. Two twist caps.
The weight limit for air conditioners is 110 lbs. It is your responsibility to insure that an air
conditioner installed on your trailer does not exceed the weight limit. Exceeding this
weight can damage the roof and lifter system which will not be covered by your Jayco
Limited Warranty. Verify that the brand of air conditioner installed on your trailer
complies with all necessary codes and weight limits.
1. Follow the air conditioner installation instructions as supplied with the air
conditioner.
2. Connect the 20-amp power cord to the air conditioner as listed in the above warning.
3. Notch the interior air conditioner shroud so the cord can pass between it and the roof.
The 120-volt cord is held up to the ceiling using the two-part wire cover provided.
4. Measure the distance from the air conditioner shroud to the outer edge of the ceiling
and cut both pieces of the wire cover to this length.
5. The base side of the wire cover has an adhesive tape attached to it. Peel off the
protective film covering the adhesive.
6. Line up the wire cover between the air conditioner shroud and the outer edge of the
ceiling. Press it firmly in place.
7. Place the 120-volt cord in the wire cover base and snap the wire cover cap into the
base.
58 Jay Series/Baja/Select Folding Camping Trailer
At Camp...