Baja Marine JAY SERIES YEAR 2006 - Manual (Page 61)

• If improper operation of this bedding is observed, discontinue its use immediately
and consult your independent, authorized dealer or the manufacturer. The bed mat is
manufactured by Flair Interiors. They can be reached at 574-534-2163 or at their
website,
www.flairinteriors.com .
• This appliance has a polarized plug (one blade is wider than the other) as a safety
feature. This plug will fit into a polarized outlet only one way. If the plug does not fit
fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety feature.
• Refer to the maintenance chapter for complete care instructions.
Dinette to Bed Conversion
1. Remove the table top and cushions. Place them to the side.
2. Remove the table legs from the floor brackets and place them in one of the storage
compartments of the dinette seats. Place the storage cover back on the dinette seat.
3. Place the table top across the middle from one dinette seat to the other resting on the
front edge bracket. For comfort, make sure the table top is level with the top of the
dinette bench.
4. Position the dinette bench cushions in place across the benches and the table top.
To convert back to the booth dinette, reverse the procedures above.
DINETTE TABLE EXTERIOR USE
The dinette table is portable for use on the exterior of the trailer. To set the table up on the
exterior of the trailer:
1. Place the dinette table on the bracket installed on the exterior of the trailer at a 45º
angle.
2. Extend the leg attached to the bottom of the table out.
3. Lower the table to rest on the extended table leg. Make sure the leg is securely
supporting the table before placing items on it.
UTILITY HOOKUPS
To complete the unit set-up, the utilities should be hooked to the proper sources as supplied
by the campground. Make sure that you read, understand and follow all information
provided for complete operation of the utility systems.
Electricity
By connecting the trailer electric system to the campground electric source, or “shoreline”
power, electricity will be supplied to operate the 120-volt AC and 12-volt DC electrical
systems. When hooking up to electricity, follow these steps:
1. Make sure that all lights and electric equipment is turned off in the trailer.
2. Locate the power cord and pull it from the RV to the length required.
3. Plug into the campground power source
I
WARNING: Do not use an adapter, cheater or extension cord that will
break the continuity of the grounding circuit. NEVER remove the
Jay Series/Baja/Select Folding Camping Trailer 51
Setting Up Camp...