Propane container 63, Propane container – Baja Marine JAY SERIES YEAR 2006 User Manual
Page 73
The following label has been placed in the trailer near the range area. Please read,
understand and follow the information in this label.
I
DANGER
IF YOU SMELL PROPANE
1. Extinguish any open flames, pilot lights, and all smoking materials.
2. Do not touch electrical switches.
3. Shut off the propane supply at the cylinder valve(s) or propane supply
connection.
4. Open doors and other ventilating openings.
5. Leave area until odor clears.
6. Have the propane system checked and leakage source corrected before
using again.
FAILURE TO COMPLY COULD RESULT IN EXPLOSION
RESULTING IN DEATH OR SERIOUS INJURY.
As noted above, the presence of any propane smell is dangerous. Make sure that everyone,
including pets, are out of the RV. Do not return to the RV until the source of the propane
odor has been determined and corrected by a propane professional.
Propane Container
The container or “cylinder” is a D.O.T. approved container to hold propane in liquid form,
and is normally a 20# or 30# (9 or 14 kilograms) capacity. The open/close valve is to be
closed at all times unless hooked up to the propane system or filling the container. When
the container is disconnected from the hose, install the valve cover that is attached to the
container. This is required by the National Fire Protection Association (NFPA), other
applicable local codes and for your own safety. Do not allow the container (filled or empty)
to move or roll around while transporting to and from the filling location.
I
DANGER: All pilot lights, appliances and their igniters (see operating
instructions) must be turned off before refueling of motor fuel tanks
and/or propane containers. FAILURE TO COMPLY COULD
RESULT IN DEATH OR SERIOUS INJURY.
The components of the propane container are:
Jay Series/Baja/Select Folding Camping Trailer
63
Utilities & Systems
1
1
2
2
3
3
VAPOR
LIQUID
20%
VAPOR
SPACE
4
1. Knob to open valve to fill or to use camper.
2. Complete valve assembly.
3. “10%” valve, small brass knob or slot screw.
4. Container mounting stand.