Sharp XE-A113 User Manual

Page 13

Part

QUICK START GUIDE

Part

When not using the take-up spool (using as receipt paper):
• Cut off the excess paper using the edge of the inner cover, and

replace the printer cover. Press the

key to make sure the

paper end comes out of the printer cover and clean paper
appears.

If the paper end does not come out, open the printer
cover, and pass the paper end between the paper cutter
and the paper guide of the printer cover, and replace the
cover.

When using the take-up spool (using as journal paper):
• Insert the end of the paper into the slit in the spool. (Press the

key to feed more paper if required.)

• Wind the paper two or three turns around the spool shaft.
• Set the spool on the bearing, and press the

key to take up

excess slack in the paper.

• Replace the printer cover.

When using a paper roll as journal paper, you must change
the printing style. Refer to “Print format” in “Various
Function Selection Programming 1” section (Job code 6)
for changing the printing style.

A113_1 Quick Start Guide 06.9.11 6:35 PM Page 11

This manual is related to the following products:

XE-A113B