Bosch WFR 2450 - Manual (Page 45)

45
Connection options
A Cold water connection and
B Hot water connection (max. 140 °F // 60 °C)
min. 10 mm
or Cold water connection only with YĆpiece
min.
10 mm
q After the connection:
Turn on the water completely, and check
whether connection points are watertight.
CAUTION
The connection points are under full water
pressure. Check seal with tap fully open.
Water drainage
CAUTION
Do not bend or pull the water drainage hose.
Height difference between the placement area
of washer and the drainage point:
Maximum 110 cm // 43 inches.
Standpipe or In Wall Installation
q Use the UĆbracket. Attach the UĆbracket to the
end of the hose and insert end of hose into
standpipe or wall drain.
q Use a strap or cable tie connected to UĆbracket
to hold hose in place.
Drainage into a siphon
q Secure the connection point with a hose band
clip.