Bosch WFR 2450 - Manual (Page 36)

36
Fault Action Possible cause
Control lights do not
hi
A fuse has triggered. Switch on/replace the fuse.
shines.
Call Customer Service if this fault is repeated.
Power failure. An interrupted program will be resumed when power
returns. If the laundry is to be removed during
a power failure, proceed as described under
Emergency lock release"; see Page 29.
Appliance is in energyĆsaving mode.
This is not a fault.
Press the Select button; energyĆsaving mode is
terminated.
Program does not
start. Start/Pause
indicator light
flashes.
Start/Pause button not pressed. Press the Start/Pause button.
Program does not
start.
Loading door not closed properly. Check whether laundry is trapped in door.
start.
Door open?"
indicated in the
display field.
Close the loading door (a click should be heard).
Program continues.
Press start" is
indicated in the
display field.
End time selected but still not activated by pressing
the Start/Pause" button.
Press the Start/Pause button.
Program does not
start. Time delay" is
indicated in the
display field.
End time selected and activated. None. Appliance starts automatically.
Clock cannot be set. Program has already started; when a program has
started, the clock cannot be set.
Wait until program ends.
Set clock:" text
remains in the
display field even
though the Menu
button has been
pressed.
The setting has switched from hours to minutes;
both selection points have the same text.
None.
--:--" is
displayed instead of
the end time in the
display field.
Clock not set. Set clock; see Page 24.
End time cannot be
l t d
Clock not set. Set clock; see Page 24.
selected.
Program has already started; when a program has
started, the end time can no longer be selected.
Reselect program; see Page 26. Before starting the
program, select and start the desired end time; see
Page 19.