Bosch WFR 2450 - Manual (Page 37)

37
Fault Action Possible cause
Spin speed cannot
be selected.
Spinning is already in progress; during spinning the
speed cannot be changed.
Select speed before spinning.
Program selector is set to Drain; spinning is not
possible with this program.
If required, select another program.
Child lock cannot be
selected.
The program has already started. Child lock can be selected in pause mode.
Detergent residue in
the detergent
Detergent was damp or lumpy. Clean and dry the detergent dispenser; see Page 30.
the detergent
dispenser.
Use the dispensing aid for liquid detergents.
Water does not enter
the machine or
detergent is not
Water tap not turned on. Turn on water tap.
Program continues.
detergent is not
washed away.
Supply hose kinked or trapped. Eliminate the cause.
y
Water tap closed?"
indicated in the
Strainers in supply hose clogged. Clean the filter; see Page 32.
indicated in the
display field. Water pressure too low. Eliminate the cause.
Water cannot be
seen in drum.
This is not a fault.
The water lies below the visible part of the drum.
Washing solution is
not completely
Loose debris is blocking the pump. Clean the pump (refer to Page 31).
not completely
drained. Pump
blocked?" indicated
in the display field.
The water drainage pipe and/or drain hose is
blocked.
Clean the water drainage pipe and/or drain hose.
Water is flowing out
from underneath the
The thread of the supply hose is not tight. Tighten the thread.
from underneath the
machine.
Leak in the drain hose. Replace the drain hose.
Foam coming out of
the detergent
dispenser.
Too much detergent. Mix 1 tablespoon of fabric softener with ½ litre/1 pt
of water and pour into chamber II of the detergent
dispenser.
Reduce the amount of detergent next time.
Repeated spinning. This is not a fault.
The imbalance compensation system is attempting to
Always load large and small items together into the
drum The imbalance compensation system is attempting to
balance the load through repeated spins.
drum.
The laundry was not
spun.
Large items of clothing became entangled and could
not be distributed evenly in the drum. For reasons of
safety the highĆspeed spin cycle was automatically
suppressed.
Always load large and small items together into the
drum.