Bosch WFR 2450 - Manual (Page 38)

38
Fault Action Possible cause
Program duration
extended.
This is not a fault.
The foam detection feature has activated an
additional rinsing cycle to reduce the amount of
foam.
Add a more appropriate amount of detergent next
time.
This is not a fault.
The imbalance compensation system is attempting to
balance the load through repeated spins.
Always load large and small items together into the
drum.
Unsatisfactory
washing result.
The degree of soil was higher than estimated. Select suitable program
or
Power Wash as an additional option.
Not enough detergent. Add detergent according to the manufacturer's
specifications.
Detergent residue on
the laundry.
Some phosphateĆfree detergents contain
waterĆinsoluble residues that may appear as light
spots on the laundry.
Brush off spots when laundry is dry.
Grey residues on the
laundry.
Dirt accumulation from ointments, fats or oils. Add the maximum amount of detergent and select
the highest permissible temperature next time.
Fault displays
Text in display field Possible cause Action
Water tap closed?" Water tap not turned on. Turn on water tap.
Program continues.
Supply hose kinked or trapped. Eliminate the cause.
Strainer in supply hose clogged. Clean the filter; see Page 32.
Water pressure too low. Eliminate the cause.
Pump blocked?" Loose debris is blocking the pump. Clean the pump (refer to Page 31).
The water drainage pipe and/or drain hose is
blocked.
Clean the water drainage pipe and/or drain hose.
Door open?" Loading door not closed properly. Check whether laundry is trapped in door. Close the
loading door.
If the fault cannot be eliminated with the aid of
the above table: switch the appliance off, wait
5 seconds, switch the appliance on again,
select and start the program.
If the fault recurs, call customer service; see
Page 34.