Bosch MUM6N10UC - Manual (Page 21)

21
4. Place the blender with cover on the
highĆspeed drive of the power unit.
Note the mark on the appliance and
on the blender. Turn the blender
counterclockwise with a slight
downward pressure until the jar is
firmly seated, see figure 13.
Figure 13
Placing Blender into
Operation
Normally when blending, the blender jar
should be filled with the entire amount of
material to be blended, if possible, before
switching the appliance on. The cover
and cover closure should always be in
place after filling the blender jar and
before switching the power unit to On.
Any subsequent additions to the blended
material should be made through the
cover opening, see figure 14.
For solids and/or granular material,
remove the cover closure/funnel to add
the material, as shown in figure 14a.
For liquids, the closure/funnel may be left
in place and the liquids added by pouring
it into the closure/funnel, see figure 14b.
Figure 14
Removing Contents
Before beginning to remove the contents
from the blender, make sure that the
power unit has been turned to the Off
position, O/Off". Remove the blender
from the power unit by turning the blender
clockwise while lifting. With the blender
removed from the power unit, the
contents of the blender may now be
poured into a suitable container or bowl,
as desired.