Nokia 6102 - Manual (Page 43)

S e t t i n g s
42 Copyright © 2005 Nokia
When sending or receiving data, ensure that the IR ports of the sending and
receiving devices are pointing at each other and that there are no obstructions
between the devices.
To activate the IR port of your phone to receive data using IR, select Menu >
Settings > Connectivity > Infrared .
To deactivate the IR connection, select Menu > Settings > Connectivity > Infrared .
When the phone displays Deactivate infrared? , select Yes .
If data transfer is not started within 2 minutes after the activation of the IR port,
the connection is cancelled and must be started again.
IR connection indicator
When is shown continuously, the IR connection is activated, and your
phone is ready to send or receive data through its IR port.
When blinks, your phone is trying to connect to the other device, or a
connection has been lost.
Packet data (EGPRS)
Enhanced general packet radio service (EGPRS), packet data, is a network service
which allows mobile phones to send and receive data over an Internet protocol
(IP)-based network. It enables wireless access to data networks such as the Internet.
The applications that may use packet data are MMS, browsing sessions, e-mail,
remote SyncML, Java application downloading, and the PC dial-up.
To define how to use the service, select Menu > Settings > Connectivity >
Packet data > Packet data connection .
Select When needed to set the packet data connection to be established when an
application needs it. The connection will be closed when the application is terminated.
Select Always online to set the phone to automatically connect to an packet data
network when it is switched on.
indicates a packet data connection.
Modem settings
You can connect the phone using an IR or a data cable (CA-42) connection to a
compatible PC, and use the phone as a modem to enable packet data connectivity
from the PC.
To define the settings for connections from the PC, select Menu > Settings >
Connectivity > Packet data > Packet data settings > Active access point , activate
the access point you want to use, and select Edit active access point . Select Alias
for access point , and enter a nick name for the currently selected access point.
Select Packet data access point , and enter the access point name (APN) to establish
a connection to an EGPRS network.