When writing or rewriting – Toshiba Satellite L30 (PSL33) User Manual
Page 73
User’s Manual
4-11
Operating Basics
■
Since the disc is based on the DVD standard, it might be filled with
dummy data if the written data is less than about 1 GB. Even if you write
only a small amount of data, it might take time to fill in the dummy data.
■
DVD-RAM formatted by FAT32 cannot be read in Windows
®
2000
without DVD-RAM Driver Software.
■
When multiple drives that can write data to discs are connected, be
careful not to write to the wrong drive.
■
Be sure to connect the AC adaptor before you write or rewrite.
■
Before you enter Standby/Hibernation Mode, be sure to finish
DVD-RAM writing. Writing is finished if you can eject DVD-RAM media.
■
Be sure to close all other software programs except the writing
software.
■
Do not run software such as a screen saver, which can put a heavy load
on the CPU.
■
Operate the computer at full power. Do not use power-saving features.
■
Do not write while virus check software is running. Wait for it to finish
and then disable virus detection programs including any software that
checks files automatically in the background.
■
Do not use hard disc utilities, including those intended to enhance HDD
access speed. They may cause unstable operation and data damage.
■
Write from the computer's hard disc drive to the CD/DVD. Do not try to
write from shared devices such as a LAN server or any other network
device.
■
Writing with software other than TOSHIBA Disc Creator is not
recommended.
When writing or rewriting
Please observe/consider the following when you write or rewrite to a CD-R/
-RW, DVD-R/-RW/-RAM or DVD+R/+RW disc.
■
Do not perform any of the following actions when writing or rewriting:
■
Change users in the Windows
®
XP operating system.
■
Operate the computer for any other function, including using a
mouse or TouchPad or closing/opening the LCD panel.
■
Start a communication application such as a modem.
■
Apply impact or vibration to the computer.
■
Install, remove or connect external devices, including the following:
PC Card, USB devices, external display, optical digital devices.
■
Use the audio/video control buttons to reproduce music or voice.
■
Open the DVD Super Multi drive.
■
Do not use shut down/log off and Standby/Hibernation Mode while
writing or rewriting.
■
Make sure writing or rewriting is completed before going into Standby/
Hibernation Mode. Writing is completed if you can open the DVD Super
Multi drive tray.