Toshiba ML933 - Manual (Page 46)

46
CONTROLS AND FEATURES
En
glis
h
USB HDD Record Function
This function can be used to record and play digital
broadcast programmes. Read the precautions
below before recording or viewing programmes
using the USB HDD record function.
NOTE:
• In order to use this function a USB flash memory or USB HDD
needs to be connected to the TV.
• Recorded programmes saved on the USB HDD can only be
viewed on this TV. They cannot be viewed when connected
to another TV (including the same model of TV), a PC, or
other device.
• You cannot watch one channel while recording another.
• If the recording time to the USB HDD is too short, no data
may be saved.
• You cannot record video input signals on the USB HDD.
• Not all types of broadcast may be recordable.
• After programming the TV to record digital broadcasting,
do not disconnect the power plug before recording starts.
Also, leaving the power switch “ON” until recording is
scheduled to start, may cause the recording to fail.
• Should video or audio recording fail due to malfunction of
the TV or poor reception, no compensation shall be paid.
• If there is a power failure or the power plug is disconnected
during programmed recording, recording will stop and will
not resume when the power returns or the plug is
reconnected.
• Do not disconnect the power plug when the indicator LED
is lit.
• Any changes implemented by the broadcasting station may
affect programme scheduling.
• Scheduling of multiple consecutive programmes may result
in the beginning of each programme not being recorded.
• Programmed recording cannot take place if the power plug
is not connected.
• Disconnecting the power plug during recording may result
in failure to save the recorded programme.
• USB HDD recording feature is not available in all countries.
• Do not turn off the TV during recording.
• When the USB HDD is formatted, all the data stored on the
HDD will be erased.
To connect an USB HDD (not supplied)
When you connect a USB HDD to the USB port on the TV, a
prompt will appear.
a
Press C or c to select No and press OK.
NOTE: Not guaranteed to work with all USB HDD.
To record the programme currently being viewed.
a
Press the zREC button on the remote control.
The currently viewed programme will start to be
recorded.
The programme indicator (red) will be lit.
To stop recording
a
Press the v (stop) button.
A confirmation window “Do you want to stop
Recording?” will appear.
b
Press C or c to select Yes and press OK.
Recording will stop.
Setting up the USB HDD for recording
To record DTV programmes
(One Touch Recording)
To USB1 or USB2
USB cable
(not supplied)
USB HDD