Toshiba ML933 - Manual (Page 40)

40
CONTROLS AND FEATURES
En
glis
h
Setting up the Network
You can select the Network Type.
a
Press MENU / C c to highlight Setup icon.
b
Press
B
/
C c
to highlight Preferences icon and
press OK.
c
Press
B
or
b
to select Network Setup and press OK.
d
Press B or b to select Network Type and press C or
c
to select Wired or Wireless.
NOTE: If the Dual Band WLAN Adaptor is not
connected, Wireless cannot be selected.
e
If you selected Wired, see “Advanced Network Setup”
on page 42.
NOTE:
• This feature is grayed out when the Dual Band WLAN
Adaptor is not connected or Network Type is set to Wired.
• When you insert or remove the wireless LAN adaptor, you
must turn off your TV and unplug the power cord, and then
plug and turn on again.
• Continued connection of AP (Access Point) is not
guaranteed. The connection may be disconnected while
watching TV.
• Do not remove the Dual Band WLAN Adaptor when
Network Type is set to Wireless or wireless
communication is active.
There are 2 methods for Wireless Setup:
Assisted setup by using the Wi-Fi Routers notification
information.
Network name, Authentication and Encryption are decided
based on information sent from the Wi-Fi router. Security key
to be set manually.
Manual setup
Network name, Authentication, Encryption and Security Key
all to be inputted manually.
Assisted Setup
a
In the Preferences menu, press B or b to select
Network Setup and press OK.
b
Press
B
or
b
to select Network Type and press
C
or
c to select Wireless.
c
Press
B
or
b
to select Wireless Setup and press OK.
d
Press
B
or
b
to select Assisted Setup and press OK.
e
Press B or b to select the desired AP and press OK.
NOTE: Check the MAC address on the label of the AP
or in the manual, and select your AP.
f
Highlight Security Key and press OK. The Software
Keyboard window will appear.
g
Input the Security Key by using the Software
Keyboard (see page 44). To save your setting, press
the BLUE button.
NOTE:
• The Security Key must adhere to these conditions:
- TKIP/AES: 8-63 ASCII or 64 Hex characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex characters
• There is only one key ID to set for WEP encryption.
h
Highlight Done and press OK.
NOTE: If Network Name is not displayed, see step 4
and 5 in Manual Setup below to set Network Name
before pressing Done.
NOTE: Settings are not saved if BACK is pressed before Done
is selected.
Manual Setup
a
In the Preferences menu, press B or b to select
Network Setup and press OK.
b
Press
B
or
b
to select Network Type and press
C
or
c to select Wireless.
c
Press
B
or
b
to select Wireless Setup and press OK.
d
Press
B
or
b
to select Manual Setup and press OK.
e
Press B or b to select Network Name and press OK.
The Software Keyboard window will appear.
f
Input the Network Name by using the Software
Keyboard (see page 44). To save your setting, press
the BLUE button.
Wireless Setup
Recording Setup
Off
Auto
Network Setup
Teletext
Guide Type
Network Device Setup
Network Lock
3D Setup
Preferences
REGZA-LINK Setup
Network Type Wired
Network Connection Test
Advanced Network Setup
Network Setup
Wireless Setup
Wireless Setup
Assisted Setup
Manual Setup