Standby mode, Standby mode -10 – Toshiba SATELLITE M30X User Manual
Page 58

User’s Manual
3-10
Getting Started
Data saved in Hibernation Mode
When you turn off power in Hibernation Mode, the computer takes a
moment to save current memory data to the hard disk. During this time, the
Built-in HDD indicator will light.
After you turn off the computer and memory is saved to the hard disk, turn
off the power to any peripheral devices.
Standby Mode
In Standby Mode the power remains on, but the CPU and all other devices
are in effectively in a state of 'sleep'.
Standby Mode precautions
■
Before entering Standby Mode, be sure to save your data.
■
Do not remove/install memory or remove power components:
■
Do not remove/install the memory module. The computer or the
module could be damaged.
■
Do not remove the Battery Pack.
In any of the above cases, the Standby Mode configuration will not be
saved.
■
If you carry the computer on board an aircraft or into a hospital, be sure
to either switch it off fully or place it into Hibernation Mode to avoid any
radio signal interference.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.
■
If the computer is not used or accessed in any way, including receipt of
e-mail, for 15 minutes when the AC adaptor is connected, the computer
will automatically enter Standby Mode (TOSHIBA Power Management
Utility default).
■
To restore operation, press the power button.
■
If a network application is active when the computer automatically
enters Standby Mode, its status might not be restored when the
computer is next switched on. To prevent the computer from
automatically entering Standby Mode, disable the Standby function in
the TOSHIBA Power Management Utility. Open the TOSHIBA Power
Management Utility and click the Power Save Modes tab. Next select
either an AC Power or Battery Power option and then click Details.
When the Details page comes up, you can disable Standy Mode setting
be moving the slider to Never, however please note that in doing this
you will nullify the computer's Energy Star compliance.