Toshiba SATELLITE A665 - Manual (Page 187)

User’s Manual 8-17
A660/A660D/A665/A665D
Sleep and Charge function
For more information and settings, please refer to the Using the TOSHIBA
Sleep Utility section in Chapter 4, Operating Basics .
Problem Procedure
I cannot use the
“Sleep and Charge
function”. Sleep and Charge function may be disabled.
Select the “Enable Sleep and Charge” check box
in the TOSHIBA Sleep utility to enable this
function.
When there is a current overflow of the external
device connected to the compatible port, USB
bus power (DC5V) supply may be stopped for
safety reasons. When this happens, disconnect
an external device if some external devices are
connected. After that, turn the power of the
computer ON/OFF to restore the function. If this
function can not be still used even if only one
external device is connected, stop using the
external device because its current is over the
acceptable value of this computer.
Some external devices may not be able to use
the “Sleep and Charge function”. In this case,
please try one or more of the following methods.
■
Select another mode.
■
Turn OFF the computer while external
devices are connected.
■
Connect external devices after turning OFF of
the computer.
If this function can not be still used, change the
setting to disable the function and stop using this
function.
The battery depletes
quickly even when I
turned OFF the power
of the computer. If Sleep and Charge function is enabled, the
computer’s battery will discharge during
hibernation or when the computer is turned off.
Connect the AC adaptor to the computer or
disable the Sleep and Charge function.